Модуль Cisco WS-X6148A-GE-45AF

Ports per module

•48 ports (all variants). Ports are numbered (left to right)

–Top row, odd numbered ports 1-47.

–Bottom row, even numbered ports 2-48.

•Port groups

–WS-X6148-GE-TX—2

–WS-X6148A-GE-TX—6

•Port ranges per port group

–WS-X6148-GE-TX: 1-24, 25-48

–WS-X6148A-GE-TX: 1-8, 9-16, 17-24, 25-32, 33-40, 41-48

Port connector type

RJ-45 (all variants)

Cabling distance

328 ft (100 m) over Category 5, 5e, and 6 UTP/STP cable (all variants)

Buffer size

•WS-X6148-GE-TX, WS-X6148V-GE-TX, and WS-X6148-GE-45AF—1.4 MB per 8 ports

•WS-X6148A-GE-TX and WS-X6148A-GE-45AF—5.5 MB per port

QoS

•Number of egress queues: 3

•Number of ingress queues: 1

•Number of thresholds per egress queue: 2

•Number of thresholds per ingress queue: 2

Maximum frame size

•WS-X6148-GE-TX, WS-X6148V-GE-TX, and WS-X6148-GE-45AF—Up to 1518 bytes per frame

•WS-X6148A-GE-TX and WS-X6148A-GE-45AF—Up to 9216 bytes per frame

Module oversubscription rate

8:1

Supervisor engine support

Supported by the following supervisor engines:

•Supervisor Engine 2

•Supervisor Engine 32

•Supervisor Engine 32 PISA

•Supervisor Engine 720

•Supervisor Engine 720-10GE

•Supervisor Engine 2T (only supported with the WS-X6148A-GE-TX and the WS-X6148A-GE-45AF Ethernet modules)

Software support

•With Supervisor Engine 2—12.2(18)SXF2

•With Supervisor Engine 32—12.2(18)SXF

•With Supervisor Engine 32 PISA—12.2(18)ZY

•With Supervisor Engine 720—12.2(18)SXF

•With Supervisor Engine 720 and WS-F6K-GE48-AF or WS-F6K48-AF PoE daughter cards—12.2(17d)SXB (WS-X6148-GE-TX only)

•With Supervisor Engine 720-10GE—12.2(33)SXH

•With Supervisor Engine 2T—12.2(50)SY

•Catalyst OS

–WS-X6148-GE-TX—7.6(9)

–WS-X6148A-GE-TX—8.4(1)

Queues per port

WS-X6148-GE-TX, WS-X6148V-GE-TX, and WS-X6148-GE-45AF

•Tx—1p2q2t (per 8 ports)

•Rx—1p2t (per port)

WS-X6148A-GE-TX and WS-X6148A-GE-45AF

•Tx—1p3q8t

•Rx—1q2t

Chassis/slot restrictions

No chassis or slot restrictions; the module can occupy any slot in any Catalyst 6500 or Catalyst 6500-E chassis (all variants)

Bus connection

Single connection into the 32-Gbps shared bus (all variants).

Module upgrades available

PoE support

WS-X6148-GE-TX and WS-X6148A-GE-TX:

•The WS-X6148-GE-TX is field upgradeable with the WS-F6K-VPWR-GE= daughter card that supports only the Cisco prestandard.

•Both the WS-X6148-GE-TX and the WS-X6148A-GE-TX are field upgradeable with the WS-F6K-GE48-AF= daughter card that supports both the Cisco prestandard and the IEEE 802.3af standard.

Refer to the Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Notefor field upgrade procedures.

Refer to Appendix A for additional information on the PoE daughter cards.

Distributed forwarding support

Not supported.

Pluggable transceivers support

Not supported.

TDR support

All variants are supported.

Module front panel LEDs

STATUS

•Green—All diagnostics pass; the module is operational.

LINK

•Green—The port is active (the link is connected and operational).

•Flashing orange—The port failed diagnostics and is disabled.

•Orange—The port is disabled.

•Red—The module is resetting; an overtemperature condition has occurred.

Note If the module fails to download code and configuration information successfully during the initial reset, the LED stays red; the module does not come online.

•Off—The port is not active or the link is not connected.

PHONE

•Green—The PoE daughter card is installed and detected.

•Off—The PoE daughter card is not detected or is not installed.